2024 CTR axle nut size???

[icemansi]

I see some say 32mm and some say 36mm can anyone confirm? Gathering tools and making sure I have the correct tools for the swift spring install (throw some tips for that as well for good luck)

Sponsored

 

[Integra23]

I didnt remove the axle nut. Just unbolted tie rod, FSB link, small stablizer link, then unbolted bottom of strut and pushed the assembly down. Was a 30 minute job a side. I did have a small bottle jack for reassembly to raise the lower control arm and get it reatrached to the strut.

 

[icemansi]

I didnt remove the axle nut. Just unbolted tie rod, FSB link, small stablizer link, then unbolted bottom of strut and pushed the assembly down. Was a 30 minute job a side. I did have a small bottle jack for reassembly to raise the lower control arm and get it reatrached to the strut.

Good stuff man I appreciate it

 

[Integra23]

Good stuff man I appreciate it

Yeah, I was worried because of others mentioning removing the axle nut but once i got in there it wasn't necessary. Granted i have done this on several vehicles over the years so installation time varies based on experience.

 

[icemansi]

Yeah, I was worried because of others mentioning removing the axle nut but once i got in there it wasn't necessary. Granted i have done this on several vehicles over the years so installation time varies based on experience.

I’ve done springs in the past and have worked on cars for most my life but I don’t like to go in blind!

 

[Integra23]

I’ve done springs in the past and have worked on cars for most my life but I don’t like to go in blind!

Couple of notes
Top nut that holds strut onto the top hat will spin requiring a allen key,6mm i think. You need to hold this while turning the nut so i used a pass-through ratchet set that keeps the center of the socket open for an allen wrench to fit.
Next is the rear shocks. This is all external and dosent require accessing anything from inside the vehicle. I tore my interior out looking for the top of the shock only to find out theres nothing there.

 

[keller]

Good stuff man I appreciate it

The R has a ride height sensor. It's wise to always disconnect the linkage before pushing the lower control arm down.

Sponsored